Removing A Device From The Nec Versabay Iv Slot - NEC VERSA TXI Manual

Removing a Device from the NEC VersaBay IV Slot

Use the following steps to remove a device from the NEC VersaBay IV slot.
Use the Phoenix BaySwap utility or power off the system.
1.
Locate the NEC VersaBay IV release latch to the right of the VersaBay IV slot.
2.
Flip the latch to the open position. Then press the latch into the system to eject the
3.
device from the bay.
Pull the device out of the system.
4.
system in the VersaBay IV slot if no VersaBay IV device is installed in the slot. See
"Installing a Device in the NEC VersaBay IV Slot" for instructions on installing the
module.
Removing a device from the VersaBay IV slot
Always install the weight-saving module that ships with your
Using the System Drives and Bays 5-5