Checking/Setting System Parameters - NEC VERSA 6000 Manual

Checking/Setting System Parameters

See the following table for a list of parameters, their factory default settings,
and alternate settings. As you set each parameter, its available settings are
explained in the Item-Specific Help area in the right part of the screen.
Reset the parameters on the displayed screen to their factory default settings
by pressing
the Exit screen. Also, read "PowerPanel" near the end of this chapter for in-
formation on using a customized toolbar to change system settings with the
click of an icon.
NOTE
modem settings listed below do not apply to Asia and Europe.
PARAMETER
Main
System Time
System Date
Diskette Drive A
Diskette Drive B
Internal Hard Drives
Master
Slave
Docking Station Hard Drives*
Docking Station Master*
Docking Station Slave*
Boot Docking Station IDE*
System Memory
Extended Memory
3-4 Using Setup
. Or, reset all parameters by selecting Set Default Values on
F9
The internal modem is not available in Asia and Europe. The
Setup Parameters
DEFAULT
SETTING
HR:MIN:SEC
MO/DAY/YEAR
1.44MB, 3.5"
Not Installed
Enable
Auto
None
Disable
None
None
+
No
640K
15360KB
ALTERNATE
SETTINGS
1.2MB, 5.25"/Not Installed
1.44MB, 3.5"/1.2MB, 5.25"
Disable
BIOS Defined/None/CD/
User
BIOS Defined/Auto/CD/
User
Enable
BIOS Defined/Auto/CD/
User
BIOS Defined/Auto/CD/
User
Yes
19456KB (w/4MB card)
23552KB (w/8MB card)
39936KB (w/16MB card)
47004KB (+32MB card)