Cable Connections; Power And I/O Connector Locations; I/O Connector Descriptions - NEC VERSA 2600 Service Manual

Cable Connections

Figure 2-3 shows the external connectors for the system. Where appropriate, secure cables
by tightening the cable holding screws.
Table 2-1 describes the I/O connectors on the rear of the system. For pin assignments, see
Appendix A.
Figure 2-3
I/O Connector
IR Port
Keyboard/Mouse Port
Expansion Connector
Monitor Port
Enhanced Parallel Port
Serial Port
NOTE
If operating the system on DC power,
verify that the system has a charged battery pack
installed.
Port
Replicator Latch
IR Port
Keyboard
Mouse Port
Expansion
Port
Monitor
Port

Power and I/O Connector Locations

Table 2-1 I/O Connector Descriptions
Function
The infrared port allows the transfer of files between the NEC Versa
and an IR-equipped computer, or printing to an IR-equipped printer
without using cables.
Connects to a PS/2-style mouse, or a 101-key, external PS/2-style
keyboard.
Provides a 200-pin connector to attach the optional NEC Port
Replicator 2600.
Connects to a 15-pin external CRT.
Connects to a 25-pin parallel device.
Connects to an RS-232C device.
Setup and Operation
AC Power
Port
Serial
Port
Parallel
Port
2-3