Hard Disk Drive; Removing The Hard Disk Drive (Step1); Removing The Hard Disk Drive (Step 2) - NEC VERSA 2600 Service Manual

4-6 Field Service Guidelines

Hard Disk Drive

Make sure your NEC Versa is powered off, all external options are disconnected, and the
LCD panel is closed. Then perform the following steps:
1. Pull down the hard drive latch located on the right front of the computer.
Figure 4-2 Removing the Hard Disk Drive (Step 1)
Pull the hard drive latch forward as shown next.
2.
Figure 4-3 Removing the Hard Disk Drive (Step 2)
Continue pulling on the latch until you remove the hard drive from its bay.
3.
NOTE
The NEC Versa must be powered off while
the hard drive is being removed and installed.
Pull Down
Hard Drive Latch
Pull Out
Hard Drive Latch