Power-On Self-Test (Post) - NEC VERSA 2600 Service Manual

Versa 2600 series
Hide thumbs Also See for VERSA 2600:
Table of Contents

Advertisement

2-14
Setup and Operation
If you determine that the default BIOS needs an upgrade, to receive a copy of the BUD
contact the NECCSD Versa Diskette Fulfillment Center at (800) 842-6446, or the
NECCSD Customer Service and Support (800) 632-4525, Fax (508) 635-4666, or the
NECCSD Bulletin Board (508) 635-4706.

POWER-ON SELF-TEST (POST)

Each time the system is powered on, the system checks the working status of components
through an automatic power-on self-test (POST). The test checks the system configuration
for any discrepancies.
If the message is an Invalid Configuration message, press
ity. The system collects Setup data and lists the changes detected in the current parameter
settings. While in Setup, follow the on-screen instructions to review the settings, and make
any necessary corrections.
If no error messages appear but the system still malfunctions, check the items in the follow-
ing list.
T
The power switch for each peripheral is on.
T
All cables and power cords are tightly connected.
T
The electrical outlet is working.
T
The brightness and contrast controls for the display are adjusted properly.
T
All options are properly installed.
NOTE
You only need to update the BIOS if
NEC makes significant improvements or fixes to
the current system BIOS.
NOTE
You should only use the BIOS upgrade
diskette for the specific model.
NOTE
If the system parameters (date, time, op-
tions, etc.) were not been entered for the present
configuration, enter them when you complete the
setup procedures (see "System Parameters" in
this section).
<Fn> Esc
to enter the Setup util-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents