Cable Connections; Powering On The System - NEC VERSA 6000 Series Service Manual

2-2 Setup and Operation
Ensure that all connections are properly seated and secure.
4.
5. Slide the power button to the right to power on the computer.

Cable Connections

Figure 2-3 shows the external connectors for the system. Where appropriate, secure cables
by tightening the cable holding screws.
Table 2-1 describes the I/O connectors on the rear of the system. For pin assignments, see
Appendix A.
NOTE: Do not cover or place objects on the
AC adapter. This will allow heat to dissipate
properly.
Figure 2-2 Powering on the System
NOTE: If operating the system on DC power,
verify that the system has a charged battery pack
installed.