Powering On The System - NEC VERSA 2600 Service Manual

Versa 2600 series

Hide thumbs Also See for VERSA 2600:

User manual (165 pages)

Service manual (101 pages)

Owner's manual (72 pages)

Table Of Contents

100

101

Table of Contents

2-2

Setup and Operation

Plug one end of the AC power cable into the AC adapter and the other end into a

properly grounded 120- or 240-volt wall outlet.

Ensure that all connections are properly seated and secure.

This equipment uses an ungrounded power cable. Replace the cord if it be-

comes damaged. U.S. and Canadian replacement cords must be UL-

approved (CSA certified in Canada) type SPT-2, 18 AWG, 2-conductor cord

with a permanently attached NEMA type 5-15P plug at one end, and a per-

manently attached connector body on the other. Cord length may not ex-

ceed 15 feet. Outside the U.S. and Canada the cord must be rated for at

least 250VAC at 10 amps, and must indicate international safety agency

approval. The plug must be a type appropriate for the country where it is

used.

Obtain replacement cords at an authorized service center. The replacement

must be of the same type and voltage rating as the original cord.

Press the Power button to power on the computer.

Microphone

NOTE

Do not cover or place objects on the AC

adapter. This will allow heat to dissipate

properly.

Power

Button

Speaker

Battery Bay

CD-ROM Reader

Figure 2-2