Removing The Processor And Heat Sink - NEC PowerMate 2000 Series Service And Reference Manual

A – Heat Sink
B – Socket Tab (1 of 2)
C – Lock Lever (under heat sink)
6. Remove the processor as follows.
!
Pull out on the processor socket lock lever just enough to release the
lever from the socket, then pivot the lever up to release the processor.
!
Carefully lift up on the processor and remove it from the socket. Store
the processor in a static free bag.
7. Install a replacement processor as follows.
!
Align the notched corner of the processor with the corresponding notch
on the socket. A white triangle on the board points to the notch on the
socket.
!
Carefully align the processor pins with the socket pin holes and set the
processor into the socket.
!
Pivot the lock lever down and press it in towards the socket until it locks
in place.
3-18 Disassembly and Reassembly

Removing the Processor and Heat Sink

D – Retention Clip
E – CPU Fan
F – CPU Fan Screws (2)