Table of Contents
Advertisement
Peripheral Configuration Mode
The Peripheral Configuration Mode fields control whether
the onboard resources are manually or automatically set up.
The options are as follows.
T
Auto (default) automatically configures the IDE
devices, diskette drive, serial ports, and parallel port
during power up.
T
Manual
allows you to customize the peripheral ports.
IDE Interface (Primary and Secondary)
The Primary and Secondary IDE Interface fields enable the
IDE interface connectors on the system board. These fields
can be either "Auto" detected or "Disabled." The default is
"Auto."
Floppy Interface
The Floppy Interface field enables the diskette drive
interface connector on the system board. This field can be
either "Auto" detected or "Disabled." The default is
"Auto."
USB Interface
The Universal Serial Bus (USB) Interface field enables or
disables the USB interface ports on the system board. The
options are "Enabled" or "Disabled." The default is
"Enabled."
Serial Port (1 and 2) Address
The serial ports 1 and 2 may be "Auto" detected or
"Disabled." The default is "Auto." When "Auto" is
selected, the first free COM port is assigned.
The serial COM port and addresses are as follows. When
an option is selected for one serial port, the selection is not
available for the second port.
4-16 NEC Drivers and Utilities
provides the following options. This selection
Advertisement
Table of Contents
