Cd-Rom Reader Connectors And Jumper Settings - NEC PowerMate P2166 Series Service Manual

Table D-2 Specifications for Sixteen-Speed Lucky Goldstar CD-ROM Reader
Feature
Supported Formats
General Specifications
Interface
Capacity
Disc Loading
MTBF (power-on hours)
MTTR
Weight
Relative Humidity
(operational)
Operating Temperature

CD-ROM READER CONNECTORS AND JUMPER SETTINGS

The back of the NEC and Lucky Goldstar sixteen-speed CD-ROM readers provides the
following connectors and jumpers (see Figure D-1):
T
Analog audio line output connector — 4-pin male connector that connects the
reader to the system's sound system via an audio cable.
T
Digital audio line output connector — 2-pin male connector
T
Configuration jumpers — enables or disables the cable select feature, slave device
configuration, or master device configuration. The CD-ROM reader is factory set
as the master device on the secondary PCI/IDE channel.
T
IDE connector — connects the reader to the secondary PCI/IDE connector on the
system board via an I/O cable (see Appendix A for system board connector
locations).
T
Power connector — connects the reader to the power supply via a power supply
cable. Pin 1 provides +12V, pins 2 and 3 are ground, and pin 4 provides +5V.
CD-ROM Reader Specifications and Jumper Settings
Specification
Mixed Mode (audio and data combined) CD-DA,
Mode 1 (basic format), Mode 2 (form 1 and form 2)
Photo CD (multi-session), CD-XA Ready, CD-I Ready,
CD-Plus;
IDE/ATAPI
2048 bytes/block, Form 1 (mode 1 and mode 2
2340, 2336 bytes/block, Mode 2
Motorized Front Loading (power tray with holder)
125, 000 hours (10% duty cycle)
30 minutes
2.10 lb. (.958 kg)
10% to 80% (no condensation)
5°C to 45°C
NOTE: The front of the CD-ROM drive
contains a headphone output connector (3.5 mm
mini-jack).
D-3