Appendix C Hard Disk Drive Specifications And Jumper Settings; Hard Disk Drive Specifications - NEC PowerMate P2166 Series Service Manual

Appendix C
Hard Disk Drive Specifications and
Jumper Settings
This appendix provides specifications and jumper settings for the following hard disks used
in the PowerMate P2166M/P2200M Series computer configurations:
T
Western Digital Caviar 2.1-GB
T
Western Digital Caviar 3.2-GB
T
IBM DAQA-33240 3.2-GB
T
Quantum Fireball 3.2-GB.
NECCSD part numbers for the hard drives are provided in Sections 5.
The standard IDE hard drive is set as the master device on the primary IDE connector. The
drive is connected via a three-connector IDE cable to the system board.
The drive is auto-configurable, meaning that once the master/slave jumpers are set, the hard
disk type is automatically detected by the system and the remaining drive parameters are
automatically set by the system. (See Section 2, "Setup and Operation," for information on
auto setup using the Autotype Fixed Disk parameter.)

HARD DISK DRIVE SPECIFICATIONS

Specifications for the 3 1/2 inch IDE hard disk drives are given in Table C-1. Jumper
settings are described in the following subsections.
2-GB Hard Disk
Features (WD Caviar
ACC22100)
Physical Configuration
Formatted Capacity 2.11 GB
Actuator Type Voice coil
Number of Disks 2
Data Heads 4
Servo Type Embedded
Tracks per Inch (tpi) TBD
Table C-1 Hard Disk Drive Specifications
3-GB Hard Disk
(WD Caviar
ACC33100)
3.16 GB
Voice coil
3
6
Embedded
TBD
3-GB Hard Disk 3-GB Hard Disk
(Quantum Fireball) (DAQA-33240)
3.21 GB 3.24 GB
Rotary voice-coil Rotary voice-coil
3 3
5 6
Embedded sectored Embedded
6,775 7,257