Remove the two 3 1/2-inch hard disk drive screws; two on each side of the drive
bracket (see Figure 5-8).
Pull the drives out from the front of the bracket.
6.
Diskette Drive
Screws
Hard Disk
Drive Screws
Figure 5-8 3 1/2-Inch Diskette and Hard Disk Drive Screws
Front Panel Assembly Removal
Remove the front panel assembly from the system unit as follows.
Remove the system unit cover and 3 1/2-inch drive bracket as previously
1.
described.
Unplug the following cables from their connectors on the system board (see
2.
Appendix A for connector locations).
T
Power lamp
T
Hard disk drive busy lamp
T
Suspend button
T
Reset button
Feed the two lamp and reset cables through the hole in the front of system unit
3.
chassis when removing the front panel assembly.
4.
Remove the front panel by releasing the four tabs from the back of the front panel.
Diskette Drive
Desktop Repair
Diskette Drive
Screws
Hard Disk Drive
5-7
Hard Disk
Drive Screws