Installing A Simm; Removing A Simm - NEC PowerMate P2166 Series Service Manual

3-18 Option Installation
Use the following procedure to install a SIMM stick.

Installing a SIMM

Install a SIMM as follows.
Remove the system unit cover.
1.
Locate the SIMM sockets (see "System Board Options" earlier in th.is section).
2.
Remove any currently installed SIMMs that are not needed.
3. Install the SIMMs from the back to the front.
4. Align the notched end of the SIMM with the left side of the SIMM socket as
shown in the following figure.
Insert the SIMM at an angle into the socket.
5.
Tilt the SIMM towards the locking tabs using equal pressure at the ends of the
6.
SIMM until it locks into the socket.
Figure 3-17 Removing a SIMM
CAUTION: Before installing a SIMM, reduce
static discharge by touching the system's metal
chassis.