Download Print this page

Troubleshooting; Eu Declaration Of Conformity - Scheppach HM210L Translation Of The Original Operating Instructions

Cross-cut mitre saw
Hide thumbs Also See for HM210L:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22

17 Troubleshooting

Fault
Motor does not work
The engine runs slowly and does
not reach the operating speed.
Engine
producing
excessive
noise.
The engine does not reach full
power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/or
splinters.

18 EU Declaration of Conformity

Translation of the original Declaration of Conformity
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
We declare under our sole responsibility that the product
described here complies with the applicable directives
and standards.
Brand:
SCHEPPACH
Art. designation:
CROSS-CUT MITRE SAW -
HM210L
Item No.
5901226901
EU directives:
2014/30/EU, 2006/42/EC, 2011/65/EU*
* The object of the declaration described above fulfils the
regulations of the directive 2011/65/EU of the European
Parliament and Council from 8th June 2011, on the re-
striction of the use of certain hazardous substances in
electrical and electronic equipment.
Applied standards:
EN 62841-1:2015/A11:2022;
EN IEC 62841-3-9:2020/A11:2020;
EN IEC 55014-1:2021; EN IEC 55014-2:2021;
EN IEC 61000-3-2:2019/A1:2021;
EN IEC 61000-3-11:2019
34 | GB
Possible cause
Engine, cable or connector
defective, mains fuses blown.
Voltage too low, coils dam-
aged, capacitor burnt.
Coils damaged, motor defec-
tive.
Circuits in the network are
overloaded (lamps, other mo-
tors, etc.).
Overloading of the motor, in-
sufficient cooling of the motor.
Saw blade dull, tooth shape
not appropriate for the materi-
al thickness.
Excessive cutting pressure
and/or saw blade not suitable
for use.
www.scheppach.com
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check mains
fuses and replace as necessary
Have an electrician check the voltage. Arrange for in-
spection of the motor by a specialist. Arrange for re-
placement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other products or motors on the same
circuit.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Resharpen saw blade and/or use suitable saw blade.
Insert suitable saw blade.
Documentation authorised representative:
Matthias Herz
Günzburger Str. 69
D-89335 Ichenhausen
Ichenhausen, 23.02.2024
Simon Schunk
Division Manager Product Center
Andreas Pecher
Head of Project Management

Advertisement

loading
Need help?

Need help?

Do you have a question about the HM210L and is the answer not in the manual?

This manual is also suitable for:

5901226901