Troubleshooting Guide; There Is No Sound; To Reset; The Cd Player Does Not Play - Aiwa XR-M1000 Operating Instructions Manual

If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
Is the AC cord connected properly?
Is there a bad connection? (+ page 4)
There may be a short circuit in the speaker terminals.
~+ Disconnect the AC cord, then correct the speaker
connections.
Was an incorrect function button pressed?
Sound is emitted from one speaker only.
Is the other speaker disconnected?
The output sound is not stereo.
Is the Karaoke function turned on? (+ page 19)
An erroneous display or a malfunction occurs.
+
Reset the unit. See "To reset".
STEREO RECEIVER
There is constant, wave-like static.
Is the antenna connected properly? (+ page 5)
Is the signal weak?
+ Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
Is the system picking up external noise or multipath distortion?
* Change the orientation of the antenna.
+
Move the unit away from other electrical appliances.
CASSETTE DECK
The tape does not run.
c IS deck
in pause mode? (+ page 25)
The sound is off-balance or not adequately high.
Is the playback head dirty? (~ page 31)
Recording is not possible.
Is the erasure prevention tab on the tape broken off? (+ page
26)
Is the recording head dirty? (+ page 31)
Erasure is not possible.
Is the erasure head dirty? (+ page 31)
Is a metal tape being used?
High frequency sound is not emitted.
1s the recording/playback head dirty? (+ page 31 )
Is a tape recorded without Dolby NR played back with the Dolby
NR system operating? (+ page 25)
To reset
If an unusual condition occurs in the display windows or the
cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press
POWER
to turn the power back on while pressing
SET. Everything stored in memory after purchase is
canceled.
If the power cannot be turned off in step 1 because of a
malfunction, disconnect the AC cord. Then connect it again
and carry out step 2.
POWER
I
SET
Stereo receiver
CD
PLAYER
The CD player does not play.
Is the disc correctly placed? (+ page 20)
Is the disc dirty? (+ page 31)
Is the lens affected by condensation?
+ Wait approximately one hour and try again.
32
ENGLISH