Ai Edit Recording; To Stop Recording; To Clear The Edit Program - Aiwa XR-M1000 Operating Instructions Manual

4
STOP
I
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
m
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
7 Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
2
3
4
5
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD on the stereo receiver and load the
disc(s).
Press EDiT/CHECK on the remote control once.
"EDIT" and "AI" are highlighted.
Al EDIT
II
When "PRGM" is highlighted, press
EDIT/CHECK
again.
Press DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using-a 60-minute tape, press 6 and O.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
<, * is also available to designate the tape length.
Remaining time Programmed
6 Press REC/REC MUTE to start recording on the
first side.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press
STOP
on the cassette deck or on the CD player (or
CLEAR
on the remote control). Recording and CD play stop
simultaneously.
To clear the edit program
Press
WSTOP W
on the CD player (or
CLEAR W on
the remote control) in stop mode so that the highlighted indicator
"EDIT" on the display disappears.
To check the order of the programmed track numbers
Before recording,
press
EDIT/CHECK
on the remote control to
select a side, and press + or P on the CD player repeatedly.
Track number
Programmed track numbers
Program number
To add tracks from other discs to the edit program
If there
is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment
1
Press
EDIT/CHECK
on the remote control to select a side.
2 Press
DISC DIRECT PLAY 1-3
to select a disc,
3 Press the numbered buttons on the remote control to select
tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
m
The Al edit recording function cannot be used with discs
containing 31 tracks or more.
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
Ta~e length of recordi;g
tracks for side A
1
I
Tape side
a: First recording side (side A)
b: Second recording side (side
B)
28
ENGLISH