Continuous Play; Playing Back A Tape; Music Sensor; When Tapes Are Loaded In Both Decks - Aiwa XR-M1000 Operating Instructions Manual

Insert a tape.
1 Press DOLBY NR and turn Dolby NR on or off to
match the playback tape.
DUNR
For tapes recorded with DOLBY NR, turn on
001
NR.
For tapes recorded without DOLBY NR, turn off DO NR.
2 Press 4> PLAY/DIR to start play.
Deck number playing *Playback side indicator
The tape counter indicates the tape running length.
*Playback side indicator
: The front side is being played (forward).
<: The back side is being played (reverse),
To
begin play with the remote control
Press TAPE on the stereo receiver or on the remote control
first, Then, press 4 b PLAY on the remote control to start play.
When tapes are loaded in both decks
Press
TAPE first to select a deck.
The selected deck number is displayed.
To
stop play,
press STOP (or CLEAR on the remote control).
To pause play, press II PAUSE (or I I SET on the remote control).
To resume play, press again.
To
change the playback side,
press < FPLAY/DIR in play or
pause mode,
To
fast forward or rewind,
press+ MS or -M$. Then press
ESTOP (or CLEAR on the remote control) to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE on the stereo receiver. The power is turned on and
play of the inserted tape begins.
TO
set
the tape counter to 0000
Press STOP (or CLEAR on the remote control) in stop mode.
The counter is also set to 0000 when the cassette holder is
opened and closed.
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press W MS or FPl MS during playback referring to the
playback side indicator (< or P) on the display,
For example, when PFIMS is pressed while - is displayed,
playback of the next track starts.
The music sensor function may not be able to detect tracks under
the following conditions:
Bla]nks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low overall recording levels
11
3 4
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press TAPE on the stereo receiver to select the
deck to be played back first.
Press REV MODE to select 1).
Press < PLAY/DIR to start playback.
Pllayback continues until STOP is pressed.
ENGLISH
25