General; Connecting Optional Equipment; Listening To External Sources; Video/Aux Jacks - Aiwa XR-M1000 Operating Instructions Manual

CD DIGITAL OUT
LINE OUT MD VIDEO/AUX
(OPTICAL)
d
DX-NM1OOO
e
SUPER SURROUND
WOOFER
Refer to the operating instructions of the connected equipment
for details.
The connecting cords are not supplied. Obtain the necessary
connecting cords.
Consult your local Aiwa dealer for optional equipment,
The MX-NMI 000 can input analog sound signals through these
jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to VIDEO/AUX R jack, and the white plug
to VIDEO/AUX L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
It is recommended that this jack be used to connect an MD player.
Use a cable with RCA phono plugs.
Connect the red plug to MD R jack of the MX-NM1OOO, and the
white plug to MD L jack,
The MX-NMIOOO can output analog sound signals through these
jacks.
Use a cable with RCA phono plugs to connect audio equipment
with LINE IN (analog input) jacks,
Connect the red plug of a cable to LINE OUT R jack, and the
white plug to LINE OUT L jack.
Do not connect any equipment to LINE OUT jacks and VIDEO/
AUX jacks simultaneously. Otherwise, noise is generated and
malfunction occurs.
Connect optional surround speakers with 8 to 16 ohm impedance
to SURROUND jacks of the MX-NM1OOO.
CD DIGITAL OUT (OPTICAL) JACK
The DX-NM1OOO can output CD digital sound signals through
this jack. Use an optical cable to connect digital audio equipment
(DAT deck, MD recorder, etc.).
Remove the dust cap ~ from CD
DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to CD
DIGITAL OUT
(OPTICAL)
jack.
When CD DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap @.
POWER
1
V,A
To play equipment connected to VIDEO/AUX jacks or MD jacks
proceed as follows.
1 Press VIDEO/AUX or MD.
To play the equi~ment connected to VI DEO/AUX, press
VIDEO/AUX. "VIDEO"
appears on the display.
To play the eauipment connected to MD, press MD. "MD"
appears on the display,
2 Play the connected equipment.
To change a source name in the display
When VIDEO/AUX is pressed, "VIDEO" is displayed initially. It
can be changed to "AUX" or '<TV.
With
the power on, press
POWER
while pressing VIDEO/AUX.
Repeat the procedure to select one of the names.
To adjust the sound level of the external
source
When the sound level of the external
source is much higher or
much lower than that of other function sources, adjust it as follows.
1 Press VIDEO/AUX or MD and play the equipment.
2 Press V or
A
so that the sound level becomes the same
as that of the other function sources.
m
During recording, the sound level can not be adjusted.
Connect optional powered sub woofers with built-in amplifier to
SUPER WOOFER jacks of the MX-NM1OOO,
30
ENGLISH