Changing The Rear Direction Indicator Bulbs - APRILIA SR 50 - 2003 Manual

◆ Remove the protection screen (2).
◆ Unscrew and remove the screw (3).
CAUTION
A focal lens is positioned in the inner part
of the coloured screen; take care not to
invert the right and left screen.
◆ Remove the coloured screen (4).
◆ Press the bulb (5) slightly and rotate it
anticlockwise.
◆ Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
making the two bulb pins match the relevant
guides on the socket.
◆ Correctly install a new bulb of the same
type.
For the reassembly:
NOTE
Upon reassembly, correctly position
the protection screen (2) in its seat.
Do not invert the position of the screws (1)
and (3).
CAUTION
Tighten the screw (1) and the screw (3)
moderately and with great care, in order to
avoid damaging the protection screen (2)
and the coloured screen (4).
7
8
CHANGING THE REAR
DIRECTION INDICATOR
BULBS
Carefully read p. 71 (BULBS).
◆ Position the vehicle on the centre stand,
see p. 43 (POSITIONING THE VEHICLE
ON THE STAND).
NOTE
Before changing a bulb, check the
fuse, see p. 70 (CHANGING THE FUSES).
◆ Unscrew and remove the screw (6).
NOTE
While removing the protection
screen, proceed carefully in order not to break
6
the cog.
◆ Remove the protection screen (7).
NOTE
Upon reassembly, correctly position
the protection screen in its seat.
Tighten the screw (6) moderately and
carefully, to avoid damaging the protection
9
screen.
◆ Press the bulb (8) slightly and rotate it
anticlockwise.
◆ Extract the bulb (8) from its seat.
NOTE
Insert the bulb in the bulb socket,
making the two bulb pins match the relevant
guides on the socket.
◆ Correctly install a new bulb of the same
type.
NOTE
If the bulb socket (9) goes out of its
seat, insert it correctly, making the bulb
socket opening match the screw seat.
use and maintenance SR 50
73