Table of Contents
Advertisement
Chapter 12 System
Figure 151 System > General Configuration
Each field is described in the following table.
Table 145 System > General Configuration
LABEL
Stored Log Days
Default Chart Type
DNS Reverse
Hostname Reverse
Low Free Disk Mark
Apply
Reset
12.1.1 Configuring for Hostname Reverse
Besides enabling hostname Do the following to allow the hostname reverse function to work.
• Turn on hostname reverse in Vantage Report.
318
DESCRIPTION
Enter the number of days that Vantage Report should keep logs and traffic
information. Vantage Report automatically deletes logs and traffic information
that are older than this. You cannot generate statistical reports or look at logs for
information older than this. This affects scheduled reports too because they can
only use whatever information is stored in Vantage Report. If you want
scheduled reports to have a complete set of information, you should set this
field accordingly.
When Vantage Report deletes data older than the time specified in this field, the
raw data (raw logs) is exported as a CSV file (.csv) and compressed into a .zip
file. These .zip files are stored in <Vantage Report installation
directory>\data\backup\csv.
Select the default chart type in statistical report screens.
Select Enable if you want Vantage Report to do reverse DNS lookups in
statistical reports. It has no effect in Log Viewer. In reverse DNS lookups,
Vantage Report looks for the domain name associated with IP addresses that it
displays. If Vantage Report finds the domain name, it displays the domain name
and the IP address in the field. If it does not find the domain name, it only
displays the IP address. This feature might increase the amount of time it takes
to display statistical reports, however.
Select Enable if you want Vantage Report to display the host names for local
computers instead of IP addresses. It has no effect in Log Viewer. In hostname
reverse lookups, Vantage Report looks for the host name associated with local
IP addresses that it displays. If Vantage Report finds the host name, it displays
the host name and the IP address in the field. If it does not find the host name, it
only displays the IP address. This feature might increase the amount of time it
takes to display statistical reports, however.
You also need to configure the host computers and ZyXEL device (see
12.1.1 on page
318).
When the amount of available disk space falls below this number of gigabytes,
Vantage Report sends a notification to the e-mail address (if any) for the
user account.
Click this to save your settings and close the screen.
Click this to change the settings in this screen to the last-saved values.
Section
root
Vantage Report User's Guide
Advertisement
Table of Contents
Troubleshooting
