ZyXEL Communications VANTAGE REPORT - V3.0 User Manual page 390

Appendix D ZyWALL 1050 Log Descriptions
Table 200 IKE Logs (continued)
LOG MESSAGE
Send DPD response to
"%s:%s"
Send:[ID]%s[SA]%s[KE]%
s[ID]%s[CERT]%s[CR]%s[
HASH]%s[SIG]%s[NONCE]%
s[DEL]%s[VID]%s[ATTR]%
s[
Start Phase 2: Quick
Mode
The cookie pair is :
0x%08x%08x /
0x%08x%08x
The IPSec tunnel "%s"
is already established
Tunnel [%s] built
successfully
Tunnel [%s] Phase 1
pre-shared key
mismatch
Tunnel [%s] Recving
IKE request
Tunnel [%s] Sending
IKE request
Tunnel [%s] IKE
Negotiation is in
process
VPN gateway %s was
disabled
VPN gateway %s was
enabled
XAUTH fail! My name:
%s
XAUTH fail! Remote
user: %s
XAUTH succeed! My
name: %s
XAUTH succeed! Remote
user: %s
Dynamic Tunnel
[%s:%s:0x%x:%s] built
successfully
Dynamic Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel [%s:%s:0x%x:%s]
built successfully
390
DESCRIPTION
%s:%s is peer IP:Port. The device sent a DPD response sent to the
peer.
This is a combined message for outgoing IKE packets.
Indicates the beginning of phase 2 using quick mode.
Indicates the initiator/responder cookie pair.
%s is the tunnel name. When dialing a tunnel, the tunnel is already
dialed.
%s is the tunnel name. The phase-2 tunnel negotiation is complete.
%s is the tunnel name. When negotiating phase-1, the pre-shared key
did not match.
%s is the tunnel name. The device received an IKE request.
%s is the tunnel name. The device sent an IKE request.
%s is the tunnel name. When IKE request is already sent but still
attempting to dial a tunnel.
%s is the gateway name. An administrator disabled the VPN gateway.
%s is the gateway name. An administrator enabled the VPN gateway.
%s is the my xauth name. This indicates that my name is invalid.
%s is the remote xauth name. This indicates that a remote user's name
is invalid.
%s is the my xauth name. This indicates that my name is valid.
%s is the remote xauth name. This indicate that a remote user's name
is valid
The variables represent the phase 1 name, tunnel name, SPI and the
xauth name (optional). The phase-2 tunnel negotiation is complete.
The variables represent the phase 1 name, tunnel name, old SPI, new
SPI and the xauth name (optional). The tunnel was rekeyed
successfully.
The variables represent the phase 1 name, tunnel name, SPI and the
xauth name (optional). The phase-2 tunnel negotiation is complete.
Vantage Report User's Guide