Table 181 Ike Logs - ZyXEL Communications VANTAGE REPORT - V3.0 User Manual

Appendix C ZyNOS Log Descriptions
Table 180 IPSec Logs (continued)
LOG MESSAGE
Rule [%s] receives an
echo reply from peer
Delete all tunnels

Table 181 IKE Logs

LOG MESSAGE
Active connection allowed
exceeded
Start Phase 2: Quick Mode
Verifying Remote ID failed:
Verifying Local ID failed:
IKE Packet Retransmit
Failed to send IKE Packet
Too many errors! Deleting SA
Phase 1 IKE SA process done
Duplicate requests with the
same cookie
IKE Negotiation is in process The router has already started negotiating with the peer for
No proposal chosen
Local / remote IPs of
incoming request conflict
with rule <%d>
Cannot resolve Secure Gateway
Addr for rule <%d>
Peer ID: <peer id> <My remote
type> -<My local type>
vs. My Remote <My remote> -
<My remote>
vs. My Local <My local>-<My
local>
Send <packet>
360
DESCRIPTION
The device received a ping response when checking the specified
VPN tunnel's connectivity.
The device disconnected all IPSec tunnels.
DESCRIPTION
The IKE process for a new connection failed because the limit
of simultaneous phase 2 SAs has been reached.
Phase 2 Quick Mode has started.
The connection failed during IKE phase 2 because the router
and the peer's Local/Remote Addresses don't match.
The connection failed during IKE phase 2 because the router
and the peer's Local/Remote Addresses don't match.
The router retransmitted the last packet sent because there
was no response from the peer.
An Ethernet error stopped the router from sending IKE
packets.
An SA was deleted because there were too many errors.
The phase 1 IKE SA process has been completed.
The router received multiple requests from the same peer
while still processing the first IKE packet from the peer.
the connection, but the IKE process has not finished yet.
Phase 1 or phase 2 parameters don't match. Please check all
protocols / settings. Ex. One device being configured for
3DES and the other being configured for DES causes the
connection to fail.
The security gateway is set to "0.0.0.0" and the router used
the peer's "Local Address" as the router's "Remote Address".
This information conflicted with static rule #d; thus the
connection is not allowed.
The router couldn't resolve the IP address from the domain
name that was used for the secure gateway address.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
A packet was sent.
Vantage Report User's Guide