Configuring Protocol Filter Rules - ZyXEL Communications P-660HW-Tx v3 User Manual
Zyxel 802.11g wireless adsl2+ 4-port gateway
Hide thumbs
Also See for P-660HW-Tx v3:
- User manual (428 pages) ,
- Support notes (116 pages) ,
- Quick start manual (10 pages)
Table of Contents
Advertisement
Chapter 11 Packet Filter
Table 55 Security > Packet Filter > Edit (Protocol Filter) (continued)
LABEL
Filter Type
Protocol
SA
DA
Modify
Back
Apply
Cancel
11.2.3 Configuring Protocol Filter Rules
Use this screen to configure protocol filter rules. In the Edit (Protocol Filter)
screen, click an Edit icon to display the following screen.
Figure 76 Security > Packet Filter > Edit (Protocol Filter) > Edit Rule
214
DESCRIPTION
This field displays whether the filter type is a protocol filter or generic
filter.
This field displays the upper layer protocol.
This field displays the source IP address.
This field displays the destination IP address.
Click the Edit icon to configure a filter rule.
Click the Remove icon to delete a filter rule.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HW-Tx v3 User's Guide
Advertisement
Table of Contents
Troubleshooting
