Ies-708-22A Access And Login - ZyXEL Communications IES-22A User Manual

Chapter 56 Troubleshooting
1 Make sure you understand the normal behavior of the LED. See
2 Check the hardware connections. See
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the IES-708-22A.
5 If a LAN port LED is off, follow these steps.
5a Check the Speed Mode settings in the ENET Port Setup screen. Make sure that
5b Check the Ethernet cable and connections between the LAN port and the peer
5c Make sure the peer Ethernet device is functioning properly.
6 If the problem continues, contact the vendor.

56.2 IES-708-22A Access and Login

I forgot the IP address for the IES-708-22A.
1 The default IP address is 192.168.1.1.
2 Use the console port to log in to the IES-708-22A.
3 If this does not work, you have to reset the device to its factory defaults. See
56.1 on page
I forgot the password.
1 The default password is 1234.
2 If this does not work, you have to reset the device to its factory defaults. See
56.1 on page
I cannot see or access the Login screen in the web configurator.
1 Make sure you are using the correct IP address.
• The default IP address is 192.168.1.1.
• If you changed the IP address
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
2 Make sure your Internet browser does not block pop-up windows and has JavaScripts
and Java enabled. See
378
the LAN port's connection speed is set to match that of the port on the peer Ethernet
device.
Ethernet device.
377.
377.
I forgot the IP address for the IES-708-22A.
Appendix B on page
Chapter 2 on page 45.
(Chapter 11 on page 99), use the new IP address.
419.
Section 3.1 on page 49.
Section
Section
IES-708-22A User's Guide