Alarm Profile Set Command; Alarm Profile Delete Command - ZyXEL Communications IES-22A User Manual

53.3.2 Alarm Profile Set Command

Syntax:
ras> shdsl alarmprofile set <profile> [atten <atten>] [snrmgn <snrmgn>]
--> [es <es>] [ses <ses>][crc <crc>] [losws <losws>] [uas <uas>]
where
<profile>
<atten>
<snrmgn>
<es>
<ses>
<crc>
<losws>
<uas>
This command configures DSL port alarm thresholds. The IES-708-22A sends an alarm trap
and generates a syslog entry when the thresholds of the alarm profile are exceeded.
Configure alarm profiles first and then use the
them with specific DSL ports.
The following example sets an alarm profile named SESalarm that has the IES-708-22A send
an alarm trap and generate a syslog whenever the connection's number of severely errored
seconds exceeds three within a 15 minute period.
ras> shdsl alarmprofile set SESalarm ses 3

53.3.3 Alarm Profile Delete Command

Syntax:
ras> shdsl alarmprofile delete <profile>
where
<profile>
This command allows you to delete an individual alarm profile by its name. You cannot delete
the DEFVAL alarm profile.
IES-708-22A User's Guide
A name for the alarm profile (up to 31 English keyboard
=
characters).
The permitted loop attenuation of a port, 0~127
=
The permitted signal to noise ratio margin, 0~15.
=
The number of Errored Seconds (0~900) that are permitted to
=
occur within 15 minutes.
The number of Severely Errored Seconds (0~900) that are
=
permitted to occur within 15 minutes.
The number of Cyclic Redundancy Checking anomalies that
are permitted to occur within 15 minutes.
The number of Loss Of Sync Word Seconds (0~900) that are
permitted to occur within 15 minutes.
The number of UnAvailable Seconds (0~900) that are permitted
=
to occur within 15 minutes.
shdsl alarmprofile map
The name of an alarm profile.
=
Chapter 53 DSL Commands
command to use
341