Table of Contents
Advertisement
Chapter 37 Alarm
Figure 120 Alarm > Alarm Port Setup
The following table describes the labels in this screen.
Table 85 Alarm > Alarm Port Setup
LABEL
Alarm Status
Alarm Event Setup
Port
Severity
Apply
Cancel
234
DESCRIPTION
Click Alarm Status to go to a screen that displays the alarms that are currently
in the system (see
Section 37.2 on page
Click Alarm Event Setup to go to a screen where you can configure the
severity level of an alarm(s) and where the system is to send the alarm(s). See
Section 37.4 on page
231.
This column lists the device's individual DSL and Ethernet interfaces.
Select an alarm severity level (Critical, Major, Minor or Info) as the threshold
for recording alarms on this port. Critical alarms are the most severe, major
alarms are the second most severe, minor alarms are the third most severe and
info alarms are the least severe.
Click Apply to save your changes to the IES-708-22A's volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
229).
IES-708-22A User's Guide
Advertisement
Table of Contents
Troubleshooting
