Mac Count Show Command; Mac Count Enable Command - ZyXEL Communications IES-22A User Manual

Chapter 47 MAC Commands
Use MAC count commands to limit how many MAC addresses may be dynamically learned.
MAC count commands are listed next. When the MAC filter accept mode is enabled (see
Section 47.2 on page
the MAC addresses listed for the port in the MAC filter settings.

47.3.1 MAC Count Show Command

Syntax:
ras> switch mac count show [portlist]
where
[portlist]
This command displays the MAC count settings on the specified DSL port(s) or on all DSL
ports if no port is specified.
The following example displays the MAC count settings for DSL port 4.
ras> switch mac count show 4
port status count
---- ------ -----
4 V

47.3.2 MAC Count Enable Command

Syntax:
ras> switch mac count enable <portlist>
where
<portlist>
This command enables the MAC count filter on the specified DSL port(s). When the MAC
filter accept mode is enabled (see
MAC count setting and accepts all of the MAC addresses listed for the port in the MAC filter
settings.
The following example turns on the MAC count filter on DSL port 4.
ras> switch mac count enable 4
296
293), the IES-708-22A ignores the MAC count setting and accepts all of
You can specify a single DSL port <1>, all DSL ports <*> or a
=
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
128
You can specify a single DSL port <1>, all DSL ports <*> or a
=
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
Section 47.2 on page 293), the IES-708-22A ignores the
IES-708-22A User's Guide