Wap6804 Access And Login - ZyXEL Communications WAP6804 User Manual

14.2 WAP6804 Access and Login

I forgot the password.
The default password is in the device label.
1
If this does not work, you have to reset the device to its factory defaults. See
2
I cannot see or access the Login screen in the Web Configurator.
Make sure you are using the correct address.
1
• The default web address (URL) of the WAP6804 is http://zyxelsetup (for Windows) or http://
zyxelsetup.local (for Mac).
• The WAP6804's IP address depends on the operating mode. See
Chapter 3 on page 22
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
2
Start Guide and
Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
3
enabled.
Reset the device to its factory defaults, and try to access the WAP6804 with the default address.
4
If the problem continues, contact the network administrator or vendor, or try one of the advanced
5
suggestions.
Advanced Suggestions
• If your computer is connected wirelessly, use a computer that is connected to a LAN port.
I can see the Login screen, but I cannot log in to the WAP6804.
Make sure you have entered the password correctly. The default password is in the device label.
1
This can happen when you fail to log out properly from your last session. Try logging in again after 5
2
minutes.
Disconnect and re-connect the WAP6804.
3
If this does not work, you have to reset the device to its factory defaults. See
4
Chapter 14 Troubleshooting
for more information.
Section 1.3 on page 11.
WAP6804 User's Guide
82
Section 14.4 on page
Section 2.2 on page 15 and
Section 14.4 on page
84.
84.