2684 Routed Mode Commands - ZyXEL Communications IES-22A User Manual

where
<portlist>
<vpi>
<vci>
This command removes a PPVC. Removing a PPVC also deletes all of the member PVCs.
The following example removes a PPVC with VPI 8 and VCI 35 for port 5.
ras> shdsl ppvc delete 5 8 35

54.5 2684 Routed Mode Commands

This feature is available in STU-C mode only.
Use the 2684 routed mode to have the IES-708-22A add MAC address headers to 2684 routed
mode traffic from a PVC that connects to a subscriber device that uses 2684 routed mode. You
can also specify the gateway to which the IES-708-22A sends the traffic and the VLAN ID tag
to add. See RFC-2684 for details on routed mode traffic carried over AAL type 5 over ATM.
Use the commands in the following order to set up a 2684 routed mode PVC.
1 Use the
2 Use the
2684 routed mode traffic.
3 Use the
mode traffic. The domain is the range of IP addresses behind the subscriber's device (the
CPE or Customer Premises Equipment). This includes the CPE device's LAN IP
addresses and the IP addresses of the LAN computers.
4 Use the
IP addresses of CPE devices using 2684 routed mode and configure how long the device
is to store them.
5 For upstream traffic: Since the subscriber's device will not send out a MAC address, after
the IES-708-22A reassembles the Ethernet packets from the AAL5 ATM cells, the IES-
708-22A will append the routed mode gateway's MAC address and the IES-708-22A's
MAC address as the destination/source MAC address.
6 For downstream traffic: When the IES-708-22A sees the destination IP address is
specified in the RPVC (or RPVC domain), the IES-708-22A will strip out the MAC
header and send them to the corresponding RPVC.
IES-708-22A User's Guide
The port(s) of the PPVC.
=
You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
The VPI of the PPVC.
=
The VCI of the PPVC.
=
shdsl rpvc gateway
command to configure RPVCs (2684 routed mode PVCs) for
shdsl rpvc set
shdsl rpvc route set
commands to view the Address Resolution Protocol table of
shdsl rpvc arp
Chapter 54 Virtual Channel Management
commands to configure gateway settings.
command to configure domains for 2684 routed
353