Figure 98 Advanced Application > 2684 Routed Mode > Routed Gateway; Table 63 Advanced Application > 2684 Routed Mode > Routed Gateway - ZyXEL Communications IES-22A User Manual

Figure 98 Advanced Application > 2684 Routed Mode > Routed Gateway
The following table describes the labels in this screen.
Table 63 Advanced Application > 2684 Routed Mode > Routed Gateway
LABEL
Routed PVC
Routed Domain
RPVC ARP Proxy
Gateway IP
VID
Priority
Add
Index
Gateway IP
VID
Priority
Delete
Cancel
IES-708-22A User's Guide
DESCRIPTION
Click Routed PVC to go to the screen where you can configure routed PVC
settings (see Section 28.2 on page
Click Routed Domain to open this screen where you can configure domains for
2684 routed mode traffic (see
Click RPVC ARP Proxy to go to the screen where you can view the Address
Resolution Protocol table of IP addresses of CPE devices using 2684 routed
mode and configure how long the device is to store them (see
page 193).
Enter the IP address of the gateway to which you want to send the traffic that
the system receives from this PVC. Enter the IP address in dotted decimal
notation.
Specify a VLAN Identifier to add to Ethernet frames that the system routes to
this gateway.
Select the IEEE 802.1p priority (0~7) to add to the traffic that you send to this
gateway.
Click Add to save your changes to the IES-708-22A's volatile memory.
The IES-708-22A loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
This field displays the number of the gateway entry.
This field displays the IP address of the gateway.
This field displays the VLAN Identifier that the system adds to Ethernet frames
that it sends to this gateway.
This field displays the IEEE 802.1p priority (0~7) that is added to traffic sent to
this gateway.
Select an entry's Delete check box and click Delete to remove the entry.
Clicking Delete saves your changes to the IES-708-22A's volatile memory.
The IES-708-22A loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
Chapter 28 2684 Routed Mode
190).
Section 28.3 on page 192).
Section 28.4 on
195