Table of Contents
Advertisement
C
H A P T E R
The ENET Port Setup screen allows you to configure settings for the Ethernet ports.
To open this screen, click Basic Setting > ENET Port Setup.
Figure 41 Basic Setting > ENET Port Setup
The following table describes the labels in this screen.
Table 17 Basic Setting > ENET Port Setup
LABEL
Port
Active
Name
Speed Mode
Duplex
Apply
Cancel
IES-708-22A User's Guide
ENET Port Setup
DESCRIPTION
This is the port index number.
Select the check box to turn on the port. Clear it to disable the port.
Enter a descriptive name that identifies this port. You can use up to 31 English
keyboard characters; spaces are allowed.
Select the type of Ethernet connection for this port. When you don't use auto-
negotiation, you must make sure that the settings of the peer Ethernet port are
the same in order to connect.
Select Auto (auto-negotiation) to have the IES-708-22A automatically
determine the type of connection that the Ethernet port has. When the peer
Ethernet device has auto-negotiation turned on, the IES-708-22A negotiates
with the peer to determine the connection speed. If the peer Ethernet port does
not have auto-negotiation turned on, the IES-708-22A determines the
connection speed by detecting the signal on the cable and using full duplex.
Select 10 Copper if the Ethernet port has a 10 MB electrical connection.
Select 100 Copper if the Ethernet port has a 100 MB electrical connection.
The IES-708-22A uses full duplex Ethernet connections by default.
Click Apply to save your changes to the IES-708-22A's volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
12
101
Advertisement
Table of Contents
Troubleshooting
