Download Print this page

FMS FCX10 Instruction Manual page 28

Toyota lc80 land cruiser
Hide thumbs Also See for FCX10:

Advertisement

车辆设置
Vehicle Setup
Battery Precautions
• Never charge a lithium polymer battery with a charger designed for NiCd, NiMH, or any other type of battery
chemistry.
• Use ONLY charger designed for LiPo battery.
• Do not leave LiPo battery unattended during charging.
• Do not overcharge the battery.
• Always charge LiPo batteries on non-flammable, heat-resistant surfaces.
• Always use a LiPo-safe bag or container while charging.
• Do not allow LiPo cells to overheat at any time.Cells which reach greater than 140 Fahrenheit(60℃) will usually
become damaged and will catch fire.
• Do not charge the LiPo pack while it is still in the model.
• Never charge or store battery packs in a vehicle.
• Do not discharge LiPo, doing so will damage the battery.
• Do not expose LiPo cell to water or moisture at any time.
• Do not store battery near open flame or heater.
• Do not assemble LiPo cells or pre-assembled packs together with other LiPo cells or packs.
• Always store LiPo battery in a secure location away from children.
• Always remove the LiPo battery if model is involved in any kind of crash.
• Carefully inspect the battery and connectors for even the smallest damage.
• CAUTION: Cells may become hot after usage. • Allow the pack to cool to room temperature prior to recharging.
• Do not allow the electrolyte to get into eyes or on skin. Wash affected areas immediately if they come into contact
with electrolyte.
• Do not alter or modify connectors or wires of a LiPo battery pack.
• Always inspect the condition of the battery before charging and operating.
• Do not short circuit the LiPo battery.
• Do not have contact with a leaky/damaged battery directly.
• Do not charge battery out of recommended temperature range(0℃-45℃)
• 不要使用NiCd、NiMH或任何其他类型的充电器给LiPO锂聚合物电池充电。
• 请使用LiPO锂聚合物的专用充电器给LiPO锂聚合物电池充电。
• 请勿在无人看管的情况下充电。
• 电池请勿过充。
• 请勿将电池放置在易燃、不耐热的表面上充电。
• 总是使用安全袋或安全容器给电池充电。
• 保证电池在任何时候都不过热。电池温度超过140华氏度(60℃)则易造成损坏,甚至引发火灾。
• 请勿将电池长期置于模型产品内,更勿在模型产品内直接充电。
• 请勿给电池放电,以免损坏电池。
• 任何时候请勿将电池暴露在水或湿气之中。
• 请勿在明火或加热器附近储放电池。
• 请勿与其他未组装或预组装的电池混用。
• 需将电池存放在远离儿童的安全位置。
• 模型如出现任何碰撞,需立刻拆除电池。 即使出现微小的损坏,也需仔细检查电池和连接器。
• 注意:使用后电池可能会发热,需让电池冷却到室温后再进行充电。
• 请勿让电解液接触眼睛或皮肤。如电解液不慎接触到身体的任何部位,请立即进行清洗。
• 请勿替换或修改电池组的连接器或电线。
• 在进行充电或其他任何操作之前需检查电池的状况。
• 请勿造成电池短路。
• 请勿直接接触已泄漏或已损坏的电池。
• 请勿超出建议温度范围充电电池(0度-45度)。
电池注意事项
27

Advertisement

loading
Need help?

Need help?

Do you have a question about the FCX10 and is the answer not in the manual?

This manual is also suitable for:

Fms11042rsgy-sp