Advertisement
User Guide
RIBBON CABLE CONNECTION BETWEEN THE ADIS16501 AND EVAL-ADIS-FX3
CABLING
The J1 connector supports connections with a 2.00 mm, insulation
displacement connector (IDC), ribbon cable assembly.
It is recommended to use 2.00 mm IDC ribbon cable assembly as
search criteria to find the latest options on the market.
At the time of initial release for the ADIS16501-2/PCBZ breakout
board, Analog Devices used the Samtec TCSD-10-S-01.00-01-N.
EVAL-ADIS-FX3 SYSTEM SETUP AND
TROUBLESHOOTING
Comprehensive setup and troubleshooting instructions are availa-
ble on the Analog Devices
Wiki
utilize the
EVAL-ADIS-FX3
evaluation system with the ADIS16501.
Detailed steps for hardware configuration, software installation, and
standard troubleshooting procedures can be found in the EVAL-
ADIS-FX3 evaluation system setup and troubleshooting guide
(see the
ADIS-FX3 Evaluation System Setup and Troubleshooting
Guide). This guide covers essential topics such as the following:
Initial hardware assembly and connections
►
Software setup and configuration
►
Diagnosing and resolving common error messages
►
If issues are encountered not covered in the
System Setup and Troubleshooting
Technical Support
In addition, to stay up to date, check for the latest version of the
EVAL-ADIS-FX3 evaluation system and firmware updates to ensure
compatibility.
analog.com
website for users intending to
ADIS-FX3 Evaluation
Guide, contact Analog Devices
EVAL-ADIS16501
Rev. 0 | 8 of 15
Advertisement
Need help?
Do you have a question about the ADIS16501-2/PCBZ and is the answer not in the manual?
Questions and answers