Structure & Handling; Commissioning - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]
2.4 Structure & Handling
The following pictures show the structure of the push-buttons:
2
1 1
1 1
2
Structure: BE-GTL4xx.x1
4
3
Back side: BE-GTLxxx.x1
Figure 2: Structure and Handling

2.5 Commissioning

1. Wire the device according to the wiring diagram.
2. Connect the interface to the bus.
3. Switch on bus voltage.
4. Press the programming button on the device.
(the status LEDs flash red alternately at the top and bottom).
5. Set and programme the individual address in the ETS (Status LEDs turn off).
6. Configure and programme the settings in the application programme.
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
2 2
1
1
2 2
Structure: BE-GTL2xx.x1
1 – Sensor surfaces
2 – RGBW Status LEDs
3 – Programming button
4 – KNX Busconnection terminal
2
1
1
2
Structure : BE-GTL1xx.x1
7 / 63
2
1
1
2