Status Led; Led Basic Setting - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4.4 Status LED

Depending on the device and its configuration, up to 4 status LEDs can be configured. One LED can be
configured for each function, which is then labelled with LED 1 - 4 in the parameters.

4.4.1 LED basic setting

The LED basic settings affect all active status LEDs.
The following table shows all available settings:
ETS Text
[off], red, green, yellow, blue, pink, cyan,
LED colour on button
activation, only with
setting "Object and
button activation"
Lock object for LEDs
■
■
Behaviour of LEDs on
■
bus power return
■
Synchronization
■
object for flashing
■
LEDs
■
Global brightness for
■
LEDs "Day"
■
■
Global brightness for
■
LEDs "Night"
■
■
Only if "Global brightness ..." → "dynamic".
Datapoint type for
■
dynamic brightness
■
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Dynamic range
[Default value]
white
not active
active
do not request LED objects
request LED objects
not active
active as master
active as slave
not active
level 1 - 5
dynamic
[level 3]
not active
level 1 - 5
dynamic
[level 1]
2 Byte DPT 9.004 Ambient
Brightness (Lux)
1 Byte DPT 5.001 Percent (0...100%)
Comment
Setting the colour.
The parameter only works if the "...
object and button activation"
parameter is selected in the relevant
LED menu under "LED reacts to".
Activates a lock object which can lock
(switch-off) all LEDs.
Setting whether the objects are
requested after a reset.
Works only when "LED reacts for:" →
"external Object".
This synchronises the flashing of
several buttons on different devices.
Setting the brightness of the LEDs if the
system is in day mode.
Setting the brightness of the LEDs if the
system is in night mode.
Setting the DPT for brightness control.
48 / 63