MDT Technologies KNX Glass Push Button II Lite Technical Manual page 40

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]
** Note: The 4 gang push-button allow you to set the button orientation to either "horizontal (left/right)"
or "vertical (top/bottom)". The settings for "Sending condition for long keypress" can vary between "...
upper/lower button" and "... left/right button".
Functional principle
Single-button function: Only one value each can be sent for short and long keypresses. The datapoint
■
type can be set separately for short and long keypresses.
Two-button function:
■
short and long keypresses.
The following table shows the associated communication objects:
No. Name/Object function
0 PB1 short: –
PB1/2 short: –
Switch, Forcible control, ...
1 PB1 short: –
PB1/2 short: – Status for toggle
2 PB1 long: –
PB1/2 long: –
Switch, Forcible control, ...
3 PB1 long: –
PB1/2 long: – Status for toggle
Table 27: Communication objects – Switch/send values short/long
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Different values for the upper/left and lower/right buttons can be sent for both,
Length
1 Bit
1 Bit
Usage
Sending the value for the short button.
DPT depending on the parameter setting.
Receive the status for the short button.
Only with the "toggle" function.
Sending the value for the long button.
DPT depending on the parameter setting.
Receive the status for the
Only with the "toggle" function.
40 / 63
long button.