Ets Parameter; General Settings; Device Selection - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4 ETS Parameter

4.1 General Settings

Important: To improve the readability of this manual, terms such as "sensor surfaces" and "sensor
activation" etc. are avoided and "buttons" and "button press" etc. are used instead.

4.1.1 Device selection

The device version of the Glass Push-Button II Lite is selected using the following parameter:
Device selection
Figure 3: General settings – Device selection
The application is customised by selecting the glass push button used. The buttons are set to a suitable
basic setting according to the version.
Note:
Since 2 gang and 4 gang push-buttons use the same application, both are set to the basic setting
"BE-GTL2Tx.01 NEUTRAL 2 gang". If a 4 gang push-button is used, it must be specified accordingly in the
device selection.
4.1.2 General settings
The following table shows the available settings:
ETS Text
Startup time
Send "In operation"
cyclically
Value for Day/Night
■
■
Behaviour after bus power return
Status for toggle
■
■
Day/Night object
■
■
Table 7: General settings
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
BE-GTL2Tx.01 NEUTRAL 2-fold
Dynamic range
[Default value]
2 ... 240 s
[2 s]
not active
1 min - 4 h
Day = 1 / Night = 0
Night = 1 / Day = 0
do not request
request
do not request
request
▼
Comment
Sets the time between restart and
functional start-up of the device.
Activation of a cyclical "In operation"
telegram.
Setting the polarity for the Day/Night
switchover.
Setting to request the "Status for Toggle"
object after bus power return.
Setting whether the "Day/Night" object is
to be requested.
18 / 63