Subfunction: Toggle Values/Scenes - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4.3.3.2 Subfunction: Toggle values/scenes

Single-button function

Two-button function

This function can be used to switch between up to 4 different values of a datapoint type.
The following table shows the available settings:
ETS Text
Button assignment
■
(1/2) (3/4)
■
Number of values
■
■
■
Datapoint type
■
■
■
■
■
■
■
■
Colour control
■
■
1. - 4. Toggle value
1. - 4. Toggle
Scene number
Delay between
switchovers
Long keypress
■
■
Button 1/2 (3/4):
■
Action on long
■
keypress
■
■
■
■
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Dynamic range
[Default value]
next/previous
previous/next
2
3
4
2 Bit DPT 2.001 Forcible control
1 Byte DPT 5.001 Percent (0...100%)
1 Byte DPT 5.005 Decimal factor (0...255)
1 Byte DPT 17.001 Scene number
2 Byte DPT 7.600 Colour temperature (K)
2 Byte DPT 9.001 Temperature (°C)
2 Byte DPT 9.004 Brightness (Lux)
3 Byte DPT 232.600 RGB value
RGB
HSV
any value
according to set datapoint type
no delay
1 s - 10 s
not active
active
1.-4. Toggle value
4. Toggle value if 1. Toggle value was
previously set, otherwise 1. Toggle value
send "0"
"OFF" to second object
"ON" to second object
save scene
[1. Toggle value]
Comment
Setting in which direction to toggle
when the upper/left or lower/right
button is pressed.
Only with two-button function.
Setting between how many values
are to be toggled.
Setting the type of datapoint to be
sent.
Selection of colour system.
Only for "RGB value".
Setting the value to be sent.
Setting a delay between sending
the toggle values.
Activating a function with a long
keystroke.
Setting the action with long
keystroke.
Number of possible switching
values according to the selection
"Number of values".
Only with two-button function
and when "long keypress" is
active.
30 / 63