Subfunction: Send Values By State - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4.3.3.4 Subfunction: Send values by state

Single-button function

This function allows a fixed value to be sent according to the selected datapoint type when pressing or
releasing the button.
The following table shows the available settings:
ETS Text
Datapoint type
■
■
■
■
■
■
■
■
Colour control
■
■
Value for pressed
button
Scene number for
pressed button
Value for released
button
Scene number for
released button
Table 22: Settings – Send values – Subfunction: Send values by state
The value to be sent can be set according to the set datapoint type for pressing as well as for releasing the
key.
The following table shows the associated communication objects:
No. Name/Object function
0 PB1: –
Forcible control, Percent value, ...
Table 23: Communication objects – Send values – Subfunction: Send values by state
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Dynamic range
[Default value]
2 Bit DPT 2.001 Forcible control
1Byte DPT 5.001 Percent (0...100%)
1Byte DPT 5.005 Decimal factor (0...255)
1Byte DPT 17.001 Scene number
2Byte DPT 7.600 Colour temperature (K)
2Byte DPT 9.001 Temperature (°C)
2Byte DPT 9.004 Brightness (Lux)
3Byte DPT 232.600 RGB value
RGB
HSV
any value
according to set datapoint type
any value
according to set datapoint type
Length
Comment
Setting the type of datapoint to be
sent.
Selection of colour system.
Only for "RGB value".
Setting the value/scene number to
be sent.
Setting the value/scene number to
be sent.
Usage
Sending the value.
DPT depending on the parameter setting.
35 / 63