Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]
ETS Text
Behaviour on long
■
keypress
■
Action on long
■
keypress
■
■
■
■
■
Sending condition for
■
long keypress
■
■
Two-button function: If "Action on long keypress" → "switch"
Value button 1/3
■
■
Value button 2/4
■
■
If "Action on long keypress" → "Send values"
Datapoint type
■
■
■
■
■
■
■
■
Colour control
■
■
Value
Scene number
RGB value
HSV value
Value
Button 1/2 (3/4)
Scene number
Button 1/2 (3/4)
Time for long
keypress
Table 26: Settings – Switch/send values short/long
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Dynamic range
[Default value]
do not send "short button"
send "short button"
switch
switch OFF
switch ON
toggle
send values
not active
upper/left and lower/right button may
send
only upper/left button may send
only lower/right button may send
OFF
ON
OFF
ON
2 Bit DPT 2.001 Forcible control
1 Byte DPT 5.001 Percent (0...100%)
1 Byte DPT 5.005 Decimal factor (0...255)
1 Byte DPT 17.001 Scene number
2 Byte DPT 7.600 Colour temperature (K)
2 Byte DPT 9.001 Temperature (°C)
2 Byte DPT 9.004 Brightness (Lux)
3 Byte DPT 232.600 RGB value
RGB
HSV
any value
according to set datapoint type
any value
according to set datapoint type
basic setting
0,1 s - 30,0 s
Comment
Setting whether the value for the
short button should also be sent .
Setting the function for the long
button.
"switch" only for two-button
function.
"switch ON" and "switch OFF"
only for single-button function.
Set the send condition for the long
button.
Only for two-button function.
** see note below table.
Setting the value to be sent.
Setting the value to be sent.
Setting the type of datapoint to be
sent.
Selection of colour system.
Only for DPT "RGB value".
Setting the value/scene number to
be sent.
Only for single-button function.
Setting the value/scene number to
be sent.
Only for two-button function.
Setting of a time from when a long
keypress is detected.
39 / 63
Need help?
Do you have a question about the KNX Glass Push Button II Lite and is the answer not in the manual?
Questions and answers