Subfunction: Switch; Subfunction: Toggle - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4.3.2.2 Subfunction: Switch

Single-button function

Here the button sends the respective fixed set value (ON
Note: For details on the Innovative group control, see
The following table shows the available communication objects:
No. Name/Object function
0 PB1: – Switch
2 PB1 Group long: – Switch
4 PB1 Group extra long: – Switch
Table 13: Communication objects – Single-button function Switch – Subfunction: Switch

4.3.2.3 Subfunction: Toggle

Single-button function

With this function, the button sends the inverted value in relation to the last received status value.
For this purpose, the status object "Status for toggle" is connected to the status of the actuator to be
controlled. If a "1" signal was received as the last value, the button sends a "0" command to the "Toggle"
object the next time it is pressed.
Note: For details on the innovative group control, see
The following table shows the available communication objects:
No. Name/Object function
0 PB1: – Toggle
1 PB1: – Status for Toggle
2 PB1 Group long: – Toggle
4 PB1 Group extra long: – Toggle
Table 14: Communication objects – Single-button function Switch – Subfunction: Toggle
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
or OFF) when pressed.
4.3.2 Switch (General).
Length Usage
1 Bit Switch function.
1 Bit Switch function for long keypress.
1 Bit Switch function for extra long keypress.
4.3.2 Switch (General).
Length Usage
1 Bit Switch function.
1 Bit Receiving the switching status of the actuator.
1 Bit Switch function for long keypress.
1 Bit Switch function for extra long keypress.
25 / 63