Subfunction: Shift Value - MDT Technologies KNX Glass Push Button II Lite Technical Manual

Technical Manual
Glass Push Button II Lite [BE-GTLxxx.x1]

4.3.3.3 Subfunction: Shift value

Two-button function

The function "shift value" can be used to move a value up or down within the set limits.
The following table shows the available settings:
ETS Text
Buttons 1/2 (3/4)
■
shift the values
■
Datapoint type
■
■
"Datapoint type" → "1 Byte DPT 5.001 Percent (0...100%)"
Lower limit
Upper limit
Step width
"Datapoint type" → "1 Byte DPT 5.005 Decimal factor (0...255)"
Lower limit
Upper limit
Step width
Repeated sending
■
with pressed button
■
Repetition time
Table 20: Settings – Send values – Subfunction: Shift value
Functional principle
The function moves the set datapoint type within the set limits. When the "downwards" button is pressed,
the set step size is subtracted from the last value and sent, and when the "upward" button is pressed, the
set step size is added to the last value and sent.
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
Dynamic range
[Default value]
downwards/upwards
upwards/downwards
1 Byte DPT 5.001 Percent
(0...100%)
1 Byte DPT 5.005 Decimal factor
(0...255)
0 - 100 %
[0 %]
0 - 100 %
[100 %]
1 - 100 %
[10 %]
0 ... 255
[0]
0 ... 255
[255]
1 ... 255
[10]
not active
active
200 ms - 3 s
[1 s]
Comment
Setting the direction of the value shift.
Select the datapoint type for the value
shift.
Setting the lower limit value.
Setting the upper limit.
Setting the step size.
Setting the lower limit value.
Setting the upper limit.
Setting the step size.
Activating the repeat send function while
holding down the button.
Repetition time between two telegrams
when the button is pressed.
33 / 63