V.34; V.90 Capabilities; Other Protocols; Fast Class (V.fc) Handshaking - 3Com 56K Command Reference Manual

V.34

V.90 Capabilities

Other Protocols

x2
Fast Class (V.FC)
Handshaking
If you enable the V.8 call indicate tone, expect to hear a sound like a fast
ringing signal while the call is being connected.
If the remote device has V.34 capability, Business Modem use a line
probing technique to determine the highest speed possible under current
line conditions, then they complete the connection. If the remote device
does not have V.34 capability, the Business Modem listens to the device's
answer tones to identify the standard rate at which the remote device is
operating, and then adjusts to that rate.
When the Business Modem answers a call, it sends out a series of answer
tone signals until both devices negotiate the best connection rate.
The Business Modem has V.90 capabilities. The Business Modem can dial into
V.90 servers to establish speeds up to 56K downstream.
For your modem to
Enable V.90
Disable V.90
x2 client modems can receive data at speeds up to 56 kbps and send data
at V.34 speeds. To use x2, the client x2 modem must connect to a server
x2 modem. If clients attempt to connect to ISPs that do not use x2, the
client modem will negotiate the next available modulation. For example,
an x2 client modem calling into an ISP that only supports V.34, the
modem will only negotiate the highest v.34 connection rate. The
maximum V.34 connection speed is 33.6 kbps.
After trying V.34, the Business Modem tries for the fastest possible V.Fast
Class (28.8 Kbps) connection. In order to negotiate V.FC, V.8 has to be
disabled. V.FC is not part of the ITUV.8 training sequence.
If the remote device is not V.FC capable, a connection is made using the
highest compatible modulation scheme (V.32 terbo, V.32 bis, and so on,
down to as low as Bell 103, or 300 bps).
V.90 Capabilities
Command
ATS58.5=0 (Default)
ATS58.5=1
12-3