Configuring Dial Security Remotely - 3Com 56K Command Reference Manual

Configuring Dial
Security Remotely
3 If Dialback is enabled at the host Business Modem's site, set your modem
to answer the host Business Modem when it dials back.
For your modem to be set
To answer the Dialback call
4 Call the host.
5 After the call ends you can disable Auto Answer.
For your modem to
Disable Auto Answer
The host administrator can configure the host's security settings remotely.
At the host device, you must have previously enabled remote access and
assigned a remote-access password that allows view-and-change
privileges (see Chapter 10, Accessing and Configuring the Business
Modem Remotely). You may want to use your administrative password as
your remote-access password.
Dialing In From the Remote Site
1 From the remote site, connect to the host using Dial Security. Once a
connection is made, follow the instructions for beginning a
remote-access session as described in Chapter 10, Accessing and
Configuring the Business Modem Remotely.
2 When remote access has been granted, use the AT%S= command to
access the Dial Security accounts. See Maintaining Security Accounts
section earlier in this chapter.
To view the security account information use
3 Make any configuration changes and execute them immediately by
entering .
AT%C2
4 To end the remote session and reactivate Dial Security on the host, reset
the host device by issuing

Configuring Dial Security Remotely

Command
ATS0=1
Command
ATS0=0
ATI10
.
ATZ
10-9
.