Configuring A Slip Connection - 3Com 56K Command Reference Manual

7 Select Enable software compression.
8 Specify an IP address by clicking TCP/IP settings.
9 After you specify an IP Address, specify server assigned name server
Configuring a SLIP
connection
1 Double-click Dial-Up Networking.
2 Click New
3 Select the Server tab and select SLIP in the Dial-up server type box.
4 Click TCP/IP settings.
5 Enter the IP address provided by your ISP.
6 Enter the primary DNS and secondary DNS server IP addresses in the
7 If your ISP requests that you use a specific frame size, select the desired
If your ISP
Gives you a specific IP address
Does not give you a specific IP address
addresses, if needed
:
If your ISP
Gives you specific name server
addresses
Does not give you specific name
server addresses
The following steps explain how to configure Windows NT for use with a
SLIP connection.
appropriate name server address boxes.
frame size in the Frame Size box.
Windows NT 4.0 and Later
Do this
Click Specify an IP address and enter
the IP address provided by your ISP
Click Server assigned IP address
Do this
Click Specify name server addresses and
enter the server address(es) provided by your
ISP
Click Server assigned server addresses
1-11