Displaying S-Register Settings; Setting An S-Register - 3Com 56K Command Reference Manual

Displaying S-Register
settings

Setting an S-Register

You can display S-Registers in a variety of ways. See the table below for
more information.
To display
Contents of ONE S-Register
S-Register settings in the NVRAM templates
S-Register settings in RAM (the current configuration)
Example: Sending
ATS0?
0.
When using the commands ATI4 and ATI5, S-Register settings appear as a
table seven columns wide, each entry of the form, "Smm=nnn" where
mm is a register number between 0 and 70 and nnn is a decimal value
between 0 and 255.
You can configure each S-Register setting manually.
CAUTION: If you do not write an S-Register setting with
will be retained only until the next reset or power off.
To change
Settings for a register in the current configuration
Example: Sending
ATS0=2
setting will cause the Business Modem to answer, in Auto Answer Mode,
on the second ring.
In the command ATSr=n, r is the register's number and n is a decimal
value from 0-255 (unless otherwise indicated) that specifies the setting.
, displays the contents or setting for S-Register
, changes the setting for S-Register 0 to 2. This
Using S-Registers 2-3
Command
ATSr?, where r is the
register's number
ATI5
ATI4
, the setting
&W
Command
ATSr=n