What You Need; Configuring Your Modem; Setting Up Ras - 3Com 56K Command Reference Manual

What you need

Configuring Your
modem
1 Go to Start | Settings | Control Panel | Modems
2 Click Add
3 Check Don't detect my modem; I will select it from a list
4 Click Next
5 Click Have Disk.
6 Place the diskette or CD-ROM that was packaged with your Business
7 Select the COM port for your Business Modem.
8 When the installation is complete, Windows NT will request that you

Setting up RAS

1 Right click on the Network Neighborhood icon on your desktop and
2 Click the Services tab.
3 Select Remote Access Service and click Properties.
4 Click Add.
5 Select your Business Modem's COM port and click OK.
6 Highlight your Business Modem and click Configure.
7 Select the function of your modem and click OK.
Before you begin, obtain the following information:
Does your ISP have a SLIP or PPP account?
Your ISP's telephone number
Does your ISP supply a static or dynamic IP address?
Your ISP's primary and secondary DNS servers
INF file for Windows NT
Since Windows NT is not Plug and Play compliant, it is necessary to install
the modem in Modem Properties.
Your modem should already be installed. If you have not connected your
Business Modem to your computer, please refer to the Getting Started
Manual for installation instructions.
Modem into your floppy disk or CD-ROM drive. Select the INF file found
on the disk.
restart your computer. Select yes.
select Properties.
Windows NT 4.0 and Later 1-9