Kyocera KM-4035 Operation Manual page 144

Troubleshooting
Error Messages
Please wait.
Remote edit.
Security key is not recognized.
Not available.
Printer Error Messages
If the Printer mode touch panel displays any of these messages after pressing the Printer key,
follow the corresponding procedure.
Error Messages
Load Paper.
## size (##)
Use alternative?
Press GO.
Set paper Press GO.
Load Paper.
Out of staples.
Add staples.
(Stapler empty.
Add staples.)
Call service.
Account ID mismatch.
Error has occurred. Change to
printer screen and check.
Option interface error
Code: ##
6-8
Checkpoints
Is Job account editing being done
from a network connected
computer?
Is it re-displayed after opening and
closing the front cover, turning off
and on the main power switch, and
plugging out and plugging in the
power plug in the power outlet?
Checkpoints
Does the print data match the feed
paper size and paper type?
—
—
Is the paper source empty?
Is the optional document finisher or
3000 sheet document finisher out of
staples?
—
—
—
Is the installed option interface slot
incorrect?
Corrective Actions
Copying is not possible until editing
is complete.
Contact your Service Representative
or Authorized Service Center.
Corrective Actions
Replace the size or type of source
paper.
To change the paper source, select
paper source from the touch panel
and press [GO].
To print on the loaded paper, press
the Printer key and press [GO].
To cancel printing, press the Printer
key and press [Cancel].
Displayed when paper source is
changed. Press [GO].
This mode supplies paper one sheet
at a time even if multiple sheets
have been loaded. To feed each
sheet, press [GO].
Load more paper.
Refer to the optional document
finisher or 3000 sheet document
finisher Operation Guide to refill
staples.
An internal error has occurred.
Contact your Service Representative
or Authorized Service Center.
No matching ID-code found. Verify
the registered ID-code using the
driver.
Shown when a printer error has
occurred when other modes are
currently being displayed. Press the
Printer key to switch to the printer
screen and display the specific error
message.
Switch the main power switch to off
( position) and install in the correct
slot.
Reference
Page
—
—
Reference
Page
page 2-2
—
—
page 2-2
—
—
—
—
—