Kyocera KM-4035 Operation Manual page 108

Basic Operation
11 If the original has been loaded with Top
edge set at the rear, select [Top Edge]
([Back Edge]). If the original has been
set to the left, press [Left Top Edge]
([Left top corner]). Press [Close] to save
the setting, or press [Back] to leave
settings as they are and return to the
screen shown in Step 8.
NOTE: The original may not be scanned correctly if original set direction is not correctly configured.
Be sure to confirm the original set direction when configuring the scanner.
12 Confirm settings, place the original, and
press the Start key.
Scanning of the original begins.
If continuous scan is enabled, proceed
to Step 13. If continuous sending is
enabled, proceed to Step 14.
13 If [Batch Scanning] is set to [On] from
[Edit] from the scanner settings screen,
after scanning is complete, a screen
prompt appears asking whether to
continue scanning or to finish.
To continue scanning, place the next
original, select scanner settings as
necessary and press the Start key.
When done, press [Scanning finished].
14
If [Continuous TX] is enabled from the
scanner settings screen, after a
transmission is complete, the scanner
settings screen is displayed with the
same settings used in the previous
transmission.
To continue, place the next original,
select scanner settings as necessary
and press the Start key.
To end the operation, press [Cancel] ([Job cancel]).
NOTE: If Permit File Overwrite is checked in Scanner File Utility, files with already existing names
will be overwritten. Exercise caution when inputting file names during Batch Scanning mode.
3-26
to scan. ( Full-Color
riginal and select destination.
tion
"Check direction of original" shown at
right side of display. Follow the steps.
If setting mode is wrong, incorrect send
will result.
Now scanning originals.
Orig. Page
.3
11×8½"
1 sided
Top Edge
UserA
User name:
riginal(s).
riginals and press start key.
nning finished" key to finish scanning.
Step .2
Top Edge
Auto
Orig. Set File Name
Direction Input
200dpi JPEG
Scanning
File Type
Resolution
Quality
Edit
Ready to scan.
Place the original and select destination.
Scan to PC-Continuous TX
Destination
Save at Address
User PC Book
)
Original Send
11×8½" 8½×11"
08/08/'05 14:00
Back Close
Select Original Image
Direction.
Left Top
Top Edge
Edge
Send
Scan to PC
8½×11"
SCAN0004_nnn.jpg
08/08/'05 14:00
Cancel
Original .1 Page
SCAN0005_nnn.jpg
Scanning
finished
( Full-Color ) Original
11×8½"
Register Prgrm Single Scan
Auto Top Edge
Select Orig. Set
Orig.Size Direction
Auto size 200dpi
Delete
Select Scanning
Send Size Resolution
Basic
Quality
08/08
08/08