Kyocera KM-4035 Operation Manual page 141

Error Messages
Check paper size.
Reposition original.
Check paper size. Copy paper is
not the same size as original.
(Paper size in cassette differs
from actual size.
Check paper size in cassette.)
Reposition original or change
cassette.
(Reset original or select another
paper cassette.)
Reset originals in processor.
Reset all originals in processor.
(Reset originals in processor.)
Reset all originals in Document
Processor.
(Reset originals in Document
Processor.)
Cannot copy this paper type.
Cannot staple this paper type.
Cannot punch this paper type.
Cannot staple this size.
(Cannot staple this paper size.)
Cannot punch this size.
(Cannot punch this paper size.)
Cannot staple.
## :maximum capacity (Staple)
(Cannot staple.
## :Max. staples)
The top tray is full of paper.
Remove paper, and press "Start"
key.
Checkpoints
Is the specified size paper loaded? Load paper of a size that can be
Is the orientation of the specified
paper different from that of the
original?
Is the specified paper loaded? Or
are the settings incorrect?
Is the orientation of the specified
paper different from that of the
original?
Is the copier installed beneath
fluorescent lights?
—
—
Are there any originals left in the
optional document processor?
Can the specified copy functions be
used with the selected paper type?
Did you select a paper type that
cannot be stapled?
Did you select a paper type that
cannot be punched?
Is stapling available for the size of
the loaded paper? For further
details, see the optional document
finisher or 3000 sheet document
finisher Operation Guide.
Is punching available for the size of
the loaded paper? For further
details, refer to the optional 3000
sheet document finisher Operation
Guide.
Is the maximum page quantity for
stapling exceeded? For further
details, see the optional document
finisher or 3000 sheet document
finisher Operation Guide.
During copying, is the maximum
capacity of the output tray
exceeded?
Corrective Actions
used.
Change the orientation of the
original. If you press the Start key
without doing so, the original will be
copied at the current size.
Load the specified paper. Adjust any
settings that are incorrect.
Change the orientation of the
original.
Do not install this machine beneath
fluorescent lights.
Remove originals from the optional
document processor, stack them
uniformly and reset them.
Remove originals from the optional
document processor, and reset them
in the original order.
Reset all originals in the optional
document processor.
Select another type of paper.
Select another type of paper.
Select another type of paper.
Change the paper size.
Change the paper size.
Decrease the number of sheets to
be stapled to less than the maximum
staple sheet count.
Remove some pages from the
output tray and press the Start key.
Printing continues.
Troubleshooting
Reference
Page
—
—
—
—
—
page 2-16
page 2-16
—
—
—
—
—
—
—
—
6-5